Orion-system VCC-X Controller Manual de usuario descargar pdf (Pagina 83)

VCC-X Operator Interface SD

APPENDIX A - SAVE, LOAD, COPY SETPOINTS

Modular Service Tool Instructions

From any menu screen, press <BALANCE-TEST>. The Unit Selec-

tion Screen

will appear requesting that you enter the unit ID number.

Enter Unit Address

Then Press Enter

Selected Unit #_1

Press Down

Enter the network unit ID for the controller you want to save the

setpoints from. Example, ‘102’ for Loop 1 / Unit 2. Then press

<ENTER>. Once communication is established, the *00* message

will go away. After a brief pause, press

<> to get to the Balance

- Test Screen shown below.

Outputs Force

Para Blocks

Save/Copy/Restore

Scroll down to the ‘Save/Copy/Restore’ option and press <ENTER>.

This will take you to the Save Setpoints screen.

System Manager SD Instructions

From any Main screen, press <SETPOINTS>. The screen below

will appear because this option requires passcode clearance. Only a

Level 2 passcode can change setpoints.

THIS ACTION REQUIRES

PASSCODE CLEARANCE

Enter Passcode: XXXX

If the correct passcode was entered, the Unit Selection Screen will

be displayed.

Enter Unit Address

Then Press Enter

Selected Unit #_1

Press Down

Enter the Unit ID of the controller you wish to save the setpoints

from and press

<ENTER>. Once communication is established, the

*00* message will go away. Then

press <>.

NOTE: If the *00* remains, it indicates a communication

failure to the controller.

The following screen will be displayed:

Change Setpoints

Configure Unit

Save/Copy/Restore

Scroll down to the ‘Save/Copy/Restore’ option and press <ENTER>.

This will take you to the Save Setpoints screen.

Save Setpoints - Network Mode

From the Save Setpoints Screen shown below:

Save Setpoints

Press Enter To Save

Press <ENTER> and a setpoint ﬁ le will be saved to the SD card.

You will receive a message that the save was successful. This ﬁ le

is speciﬁ c to this controller on this loop.

Saving & Copying Setpoints

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 95 96

Comentarios a estos manuales

Sin comentarios

Orion-system VCC-X Controller Manual de usuario Pagina 83

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Orion-system VCC-X Controller