Orion-system VAV II Controller v.1 Manual de usuario descargar pdf (Pagina 70)

APPENDIX C - UPDATING CONTROLLERS & E-BUS MODULES

VAV/CAV/MUA Operator Interface SD

Updating Controller & E-BUS Module Software

E-BUS Modules

1. Press <2> to update an E-BUS Module.

The following screen will appear:

Enter Board Address

Esc) Exit Menu

2. Enter the address of the E-BUS module you are updating

and then press

<ENTER>. The following is the list of

Module addresses:

WSHP-X - address 17

MHGRV-X - address 132

MODGAS-X - address 138

3. The Software Version Screen will appear as shown

below. Enter

<0> for the latest software version or enter

the number of an older version if given to you by

Technical Support. Then press

<ENTER>.

Software Version

Enter 0 for Latest

Esc) Exit Menu

4. The screen will display the following messages:

“Resetting Unit”

“Load Sys Info”

5. If communications are successful, the screen will

display, the name of the HEX ﬁ le on the top line,

“Flash Memory Erased” on the second line, and the

progress percentage on the third line.

NOTE: If communications are not successful, the screen

will display, “Press Any Key to Continue. Cannot Load

Sys Info.” Make sure you have the right address and the

right software version on your SD card. If these two

items are correct and you still experience a problem,

contact Technical Support.

6. When updating is complete, the screen will display,

“Finish Download.”

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 79 80

Sin comentarios

Orion-system VAV II Controller v.1 Manual de usuario Pagina 70