Orion-system PT-Link II LON Manual de usuario descargar pdf (Pagina 5)

PT-Link II Interface

PT-Link II LON

Technical Guide

Connection and Wiring Information

Figure 2: PT-Link II LON

Interface Wiring

Modular Service Tool

Mode

Selection

ENTER

CLEAR

ESC

DOWN

DEC

MINUS

STATUS

SETPOINTS

SCHEDULES

CONFIGURATION

ALARMS

OVERRIDES

BALANCE - TEST

LON Connection

To LON Network

LON Connection

To LON Network

Line Voltage

24 VAC

(8 VA)

Controller

SHLD

Typical Terminal Blocks. All

Wiring To Be T To T, SHLD

(G) To SHLD (G) & R To R

Note: All Programming Of

Controllers Must Be Done

Using The Modular Service

Tool. The Modular System

Manager Should Not Be Used

On A System That Has A PT-

Link Installed.

Caution: The LON Network

Communication Terminal Block

Must Be Disconnected Before

Connecting The Modular Service

Tool. After Programming The

Controller, Disconnect The Service

Tool and Then Reconnect The

Communication Terminal Block.

Wiring Notes:

1.) All wiring to be in accordance with local and national electrical codes

and specifications.

2.) All communication wiring to be 18 gauge minimum, 2 conductor twisted

pair with shield. Use Belden #82760 or equivalent.

Line Voltage

24 VAC

(10 VA)

Controller’s Address

Cannot Be Higher Than 16.

Revised 8/31/11

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comentarios a estos manuales

Sin comentarios

Orion-system PT-Link II LON Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Orion-system PT-Link II LON