Orion-system GPC-XP Controller Manual de usuario descargar pdf (Pagina 22)

Section 6: Conﬁ guring Relays

GPC-XP Controller Technical Guide

Main Control Method Window

Main Control Method

The Main Control Method Window (Figure 35 below) is located

on the left of the Relay Conﬁ guration Screen (Figure 34, page 21).

Figures 36 through 43 will walk you through the conﬁ guration steps

in this window. As you select items, the corresponding ﬁ elds that

you need to ﬁ ll out will become available. Fields that do not pertain

to the conﬁ guration at hand will be greyed out.

Figure 35: Main Control Method Window

Figure 36: Control Method Field

Control Method Field

● Not Conﬁ gured – Select this if this relay will not be used.

●

Above/Below Options – These options work with the Hi

Limit and Lo Limit Setpoints. See Figure 35.

• On Above / Off Below • On Above / On Below

• Off Above / On Below • Off Above / On Below

● Follow Active/Inactive Binary Input Options – If one

of these options is selected, you must then go to the Binary

Input to Follow ﬁ eld (see Figure 44, page 25)—and select

which Binary Input this Relay Output will be associated

with. If the Follow Active Binary Input is selected, this relay

will energize when the selected Binary Input is Active. If

the Follow Inactive Binary Input is selected, this relay will

energize when the selected Binary Input is Inactive. For

example, if the Main Control Method is “Follow Active

Binary Input” and the Binary Input chosen is conﬁ gured

“N/O Contact (Closes for Active)”, then this relay will

be energized when 24 VAC is applied to the binary input

and the N/O contact closes (Active). If the Binary Input

chosen is “N/C (Opens for Active)”, then this relay will be

energized when 24 VAC is removed from the binary input

and the N/C contact opens (Active).

• Follow Active Binary Input • Follow Inactive Binary Input

● Follow Relay Output – If this option is selected, you must

then go to the Relay to Follow ﬁ eld (Figure 45, page 25)

and select another relay that this relay is to follow. For

example, if you are conﬁ guring Relay #1, you can conﬁ gure

it to energize whenever Relay #2 (based on its logic)

energizes.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Sin comentarios

Orion-system GPC-XP Controller Manual de usuario Pagina 22