Orion-system VAV/Zone Controller Manual de usuario descargar pdf (Pagina 13)

VAV/Zone Controller

Technical Guide

Mode

Selection

ENTER

CLEAR

ESC

DOWN

DEC

MINUS

STATUS

SETPOINTS

SCHEDULES

CONFIGURATION

ALARMS

OVERRIDES

BALANCE - TEST

ENTER

CLEAR

ESC

DOWN

DEC

MINUS

STATUS

SETPOINTS

SCHEDULES

ALARMS

OVERRIDES

System Manager

Figure 11: Operators Interfaces

Programming The Controller

The next step is programming the controller for your specific require-

ments. In order to configure and program the VAV/Zone controller you

must have a central operators interface or a personal computer with the

Prism computer front end software installed. Two different operators

interfaces are available for programming of the VAV/Zone controller.

You may use either the Modular Service Tool or the Modular System

Manager to access the status and setpoints of any VAV/Zone controller

or VAV/CAV controller on the system’s communications loop. See the

Modular Service Tool and System Manager Programming guide for

VAV/Zone controller programming information. If you are going to use

a personal computer and the Prism computer front end software, please

see the Orion Prism Computer Front End Operations Manual. No mat-

ter which operators interface you use, it is recommended that you pro-

ceed with the programming and setup of the controller in the order that

follows:

1. Configure The Controller For Your Application

2. Program The Controller Setpoints.

3. Review Controller Status Screens To Verify System

Operation And Correct Controller Configuration

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comentarios a estos manuales

Sin comentarios

Orion-system VAV/Zone Controller Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Orion-system VAV/Zone Controller